Inspection IDReason for InspectionInspection DateInspection Status 
SIN-00289642 Renewal 06/15/2026 Compliant - Finalized
RegulationLIS Non-Compliance AreaCorrection RequiredPlans of CorrectionCorrection DatePOC Status
6400.68(b)At the time of the inspection on 6/16/26, the water temperature in the home exceeded 120 degrees. The water temperature measured at 124.5 degrees Fahrenheit in the half bath and 123.5 degrees Fahrenheit in the kitchen sink. Hot water temperatures in bathtubs and showers may not exceed 120°F. The Program Director immediately verified water temperatures in the home following the inspection findings and confirmed that hot water temperatures exceeded the regulatory limit of 120°F, with readings of 124.5°F in the half bath and 123.5°F in the kitchen sink. The water heater company was contacted to address the issue, and a technician was dispatched to service and adjust the system. The water heater was promptly calibrated to reduce and regulate the temperature in accordance with the required standard of not exceeding 120°F. Following the adjustment, water temperatures were rechecked at multiple outlets throughout the home to ensure compliance, and all readings were confirmed to be within the acceptable range. All remaining water outlets in the home were also reviewed to ensure continued compliance, and no additional concerns were identified. 07/01/2026 Implemented
6400.72(b)At the time of the inspection on 6/16/26, the first bedroom on the left when entering the hallway was missing the crank handle to open/close the window and the lever to lock/unlock the window. Additionally, the window was nailed shut. Screens, windows and doors shall be in good repair. The Program Director immediately inspected the identified bedroom window and confirmed that the crank handle and locking lever were missing and that the window was not fully operable due to being previously secured in a non-standard manner. A work order has been placed to replace the missing window crank handle and locking mechanism to restore full functionality. The replacement parts have been ordered; however, delivery and installation are pending and are expected to be completed within approximately three (3) weeks upon receipt of materials. A copy of the work order has been obtained and filed for documentation. As an immediate safety measure while awaiting repair completion, the bedroom will remain unassigned and will not be used by any individuals until the window is fully repaired and verified as operational. All other windows, screens, and doors in the home were inspected to ensure they are in good repair and fully operational. Any additional concerns identified were corrected immediately. 06/30/2026 Implemented
SIN-00273981 Renewal 09/16/2025 Compliant - Finalized
RegulationLIS Non-Compliance AreaCorrection RequiredPlans of CorrectionCorrection DatePOC Status
6400.80(b)During the inspection of the home on 9/16/25 there was a 10"x10" hole in the soffit above the front door where a previous light had been removed. The outside of the building and the yard or grounds shall be well maintained, in good repair and free from unsafe conditions.The administrator will oversee the Maintenance Staff to repair the 10"x 10" soffit hole above the front door. A full inspection of other structural areas will be conducted by the administrator, and any hazards will be corrected. 09/29/2025 Implemented